Locator Sondes for sewer and conduit locating

The Bendie Sonde is an articulated, waterproof, self-contained, AA battery powered transmitter. It can fit into lines as small as 3 inches and make a 90 degree turn or a 180 degree turn in a 4 inch line.

Using compatible receivers, the signal produced by the sonde can be traced to depths of 20 feet in both cast iron and nonmetallic pipes and drains.

	Water proof, self contained and battery powered
	Can fit and turn in lines as small as 3 inches
	Signal can be traced to depths of 20 feet
	Works both in cast iron and nonmetallic pipes and drains
	0.9" diameter
	Depths to 25 feet
	One "AA" battery

Bendie Sonde Specification

Standard Sewer Pipe Sonde

	1.5" diameter x 4 1/8"
	8 kHz or 33khz
	20 hours with one AA battery

Sewer Sonde:

	2.5" x 6 5/8"
	33 KHz
	15 hours with one 9V battery
	16' maximum depth

Sewer Sonde

Super Sonde:

	2.5" x 12 1/2"
	33 kHz
	5 hours on 1 9v battery
	50' maximum depth

Super Sonde

Super Small Sonde S18A

	.0.7" x 3 1/4"
	12' depth max.
	20 hours on two SP675 batteries

S18B conduit sonde

	Only 0.7" x 6 3/4"
	12' maximum depth
	12 hours on two AA batteries

Flex Rods

Flex Rods are constructed of a durable glass fiber rod in a polypropylene sleeve. They provide a means of rodding and locating a sewer, drain or duct. Resistant to abrasion, most solvents, oils and acids, Flex Rods can be used with all Radiodetection Sondes with M10 threaded ends. Available rod lengths range from 98 ft to 984 ft and rod diameters are 0.35 in. or 0.43 in.

Locator Flex rod

Flexi-Trace

The Flexi-Trace is a flexible fiberglass coated rod incorporating wire conductors for locating small diameter nonmetallic pipes and ducts to depths of 10 feet. Pipes or ducts with diameters as small as 0.5 inches and with a bend radius of 10 inches present are easily rodded with the FlexiTrace. Batteries are not required; the FlexiTrace is energized through the use of a compatible transmitter. Connection via two stud terminals allows the system to be energized for its entire length or just the probe at the tip.

	Works in pipes and ducts with diameters as small as0.5 inches
	Works with LCTx, HCTx2, HPTx, T10, T3 Transmitters
	Can be rodded though pipes and ducts with a 10-inch bend radius
	No batteries required
	Can be energized for its entire length of just the probe at the tip

Flexitrace pushrod

Fiberglass pipe and Conduit Tracing Pushrods

	1/8" x 195 ft (60m)
	1/4" x 195 feet or 325' (60m or 100m)
	3/8" x 130 ft or 195 ft (40m or 60m)
	Sewerin Fiberglass locate rods 262 kb

Pushrod for pipe conduit location

Pipe and Conduit Locator Sondes

Home

Pipe Inspection Cameras

Bendie Sonde